Gasboy 03908X User Manual
Introduction, Contents required reading, Required tools

MDE-4351A Gasboy ATC Kits 039086 and 039087 Installation Manual • February 2006
Page 1
Introduction
This manual provides installation instructions for the Gasboy Automatic Temperature
Compensation (ATC) Kits:
• 039086 for Twin 9800 Unit
• 039087 for Single 9800 Unit
Contents
Required Reading
Before installing a kit, the installer must read, understand, and follow:
• This manual
• NFPA 30A, The Automotive and Marine Service Station Code
• NFPA 70, The National Electric Code
• Applicable federal, state and local codes and regulations
Failure to do so may adversely affect the safe use and operation of the equipment.
Note: This kit must be installed by a Gasboy Authorized Service Contractor (ASC) to ensure
warranty.
Required Tools
The following tools are needed to install the ATC Kits:
• Open end wrench set
• Flat-tip screwdriver
• Cross-tip screwdriver
• Allen
®
wrench set
Section
Page ...
Installing the 039086 ATC Kit in Single Unit
Installing the 039087 ATC Kit in Twin Unit
Appendix: Totalizer Display Information
MDE-4351A
Gasboy ATC Kits 039086 and 039087
Installation Manual
February 2006