Gasboy Hi-Flow Sat Pipng Conversion Kits - Manual (Page 10)

Installing Atlas Hi-Flow Satellite Conversion Kits M06391K001, K002, K003 and K004
Page 10 MDE-4514 Instructions for Installing Atlas™ Hi-Flow Satellite Piping Conversion Kits M06391K00X • June 2006
4 Route the valve coil wires into the junction box. Attach the conduit to the fitting in the
junction box and tighten them.
5 Check discharge piping alignment and adjust as needed. Attach the satellite piping support
bracket (
Figure 4 ) to the dispenser inlet support plate, insert and tighten the two M8 thread
forming screws.
6 Insert the U-bolt ( Figure 4 ) around the pipe elbow and through the slots on the support bracket.
Attach two nuts and tighten all fasteners.
7 Stuff a clean rag into the elbow on the top end of the discharge line and proceed to “Modifying
the Side Sheathing for the Discharge” on page 10 .
Modifying the Side Sheathing for the Discharge
See Figure 5 on page 11 .
The use of power tools or any means to cut the sheathing hole (step 3 ) with flammable
fuels or vapors present is hazardous and can result in fire or explosion causing serious
injury or death.
Remove the sheathing from the unit and transport to a safe distance from potentially
hazardous locations to cut the sheathing hole.
WARNING
!
1 Mark the location of the discharge elbow on the side sheathing as shown in Figure 5 on page
11 . Check the dimensions against the location of the discharge elbow in the assembly to ensure
that the marked location is correct. Adjust the mark, if necessary.
2 Remove the sheathing from the unit.