Gasboy Totalizer Retro - Manual

MDE-4511B Retrofit Kits for Atlas™ Electro-mechanical and Commercial Electronic Units Installation Instructions · June 2011 Page 1
Introduction
Purpose
This document provides installation instructions for the Card System Interface and
Electro-mechanical Totalizer Kits for Atlas ™ Commercial Electronic Units:
• M06382K003 for RS-485 with Electro-mechanical Totalizers and DC Conduit
(New Bezel with Totalizer opening may be required).
• M06382K004 for Dual Units with Electro-mechanical Totalizers with Pulse-out
(Commercial Electronic Units Only).
Required Reading
Before installing a kit, the installer must read, understand, and follow:
• This manual
• NFPA 30A, The Automotive and Marine Service Station Code
• NFPA 70, The National Electric Code
• Applicable Federal, state, and local codes and regulations
Failure to do so may adversely affect the safe use and operation of the equipment.
Note: This kit must be installed by a Gasboy
® Authorized Service Contractor (ASC) to
ensure warranty.
Table of Contents
Topic Page
Introduction 1
Important Safety Information 4
Installation 6
Completing the Installation 10
Required Tools
The following tools are required for the installation of the kit:
• Open-end Wrench Set
• Flat-tip Screwdriver
• Cross-tip Screwdriver
Related Documents
Document
Number
Title GOLD Library
MDE-4255 Gasboy Warranty Policy Statement for USA and Canada • Gasboy Policy Documents
• Domestic Warranty & Owner’s Manuals
MDE-4511B
Card System Interface and Electro-mechanical Totalizer
Retrofit Kits for Atlas ™ Commercial Electronic Units
Installation Instructions
June 2011