Gasboy 9820A Series - Manual (Page 7)

03/07/03 1-1
Section 1
INTRODUCTION
PURPOSE
The GASBOY ASTRA Series 9820A Electronic Commercial Pumps Installation/Operation Manual
is provided to assist the installer in installing and operating the unit. This manual should be
supplied to the electrician prior to the installation of conduit and wiring to ensure the unit is
installed properly. Faulty installations are the major cause of unit malfunctions. The unit must be
installed and operated as described in this manual to ensure the reliability and proper operation of
the Series 9820A unit. In addition to installation information, this manual contains warnings,
safeguards and procedures on the use and care of the Series 9820A pumps. Be sure to leave this
manual with the pump owner after the installation is complete.
GENERAL DESCRIPTION
The GASBOY Series 9820A ASTRA (aboveground storage tank remote access) pump units are
UL-listed and are available in two models. Model 9822A is available in standard speed (up to 15
GPM/56 LPM) with an intermittent-duty motor. Model 9823A is available in high speed (up to 22
GPM/83LPM) with a continuous-duty motor. The delivery rate varies depending upon installation
conditions and added accessories. Both models of the 9820A offer electronic registration of the
quantity dispensed.
NOTE:
NFPA regulations do not allow tank-mounted pumps to be used for the resale of fuel.
The Series 9820A consists of two metal cabinet assemblies. One assembly is mounted on top of
the tank and contains the pumping unit, meter, electronic pulser, and all hydraulics. The hose and
nozzle are connected to this assembly. The second assembly is mounted at a height to permit
easy access by a user. It contains the electronic register, controls, display and nozzle boot.
The following lists detail the standard and optional features for the Series 9820A.
Standard Features
• One-inch high, 6-digit, backlighted LCD display
• 1000:1 dual-phase, error-checking pulser (gallons); 250:1 dual-phase, error-checking pulser
(liters)
•
AC authorization line for control of the unit
• Reset complete (switch detect) output which allows monitoring of the unit's operation when it
is connected to an automated fueling system
•
Resettable electronic totalizer
•
Discharge elbow
•
Both models use a quiet and efficient gear pump which features an air eliminator, built into
the pump casting. The pump meter is a three piston, positive displacement meter which is
tested and calibrated for accuracy at any speed or pressure up to the maximum working
pressure of 50 psi.
• The standard pumping cabinet finish is white. The electronic register cabinet is black with a
blue graphics panel.