Gasboy 9820A Series - Manual (Page 41)

Pump Operation
03/07/03 5-9
NOZZLE LOCKING
A locking mechanism is supplied as part of the hook arrangement on each 9820A. This will allow
the unit to be locked thus preventing use of the dispenser. A lock with a shackle clearance of at
least 2-1/2" is required to lock the pump (i.e., Master No. 1LJ-D). To lock the nozzle in place,
follow the instructions below:
1.
Insert the nozzle onto the hook assembly with the nozzle tip inside of the boot.
2.
Slide the rear bracket of the nozzle hook assembly upward until the holes near the bottom of
the nozzle are aligned.
3. Slide the open padlock through holes in the moveable and stationary portions of the hook
arrangement, thus capturing the nozzle in place. (Note that the four holes will not align until
the moveable bracket has been slid upward.)
4.
Close the lock.
While the nozzle is locked in place, the nozzle cannot be removed from the nozzle hook and the
dispenser cannot be turned on.