Gasboy 9820A Series - Manual (Page 44)

GASBOY Series 9820A
6-2 03/07/03
START-UP
After successfully verifying the installation against the completion checklist, the unit is ready for
start-up. Follow the procedure below to perform an orderly start-up of the Series 9820A.
1.
Verify that all switches on the CPU PCB are set properly for the various operating conditions
as explained in Section 5.
2.
Turn on the circuit breakers for the microprocessor.
3.
Authorize the unit through the fuel management system, if available.
4.
Remove the nozzle from its holder and turn on the pump handle. Verify that the display goes
through the proper reset sequence as explained in Section 5, Operating Sequence.
5. Dispense fuel. Verify that the high flow valve opens, if equipped. Check all plumbing for
leaks at this time.
6.
Turn the pump handle off. Open the nozzle. No fuel should be dispensed at this time.
7.
Verify that the correct quantity was recorded by the fuel management system, if available.
8.
Run the unit through all standard calibration procedures.
9.
Reset the electronic totalizer as described in View/Reset Totalizer in Section 5.