Gasboy 9800 Atlas - Manual (Page 16)

Installing Atlas 9800 CPU Board (M06333KXXXX)
Page 16 MDE-4652D Atlas™ 9800 Electronics Field Installation Instructions · April 2013
10 Set the new CPU Board on the standoffs. Reinstall the screws removed in step 6 on page 11 .
For models with plastic standoffs, ensure that the metal standoffs are under the mounting holes
located between P2 and P3, and the outside corner next to P5. Carefully push the new CPU
Board onto the standoffs before installing the screws.
11 Reconnect all the cables (P1 to P9, and P11), if applicable. Reconnect the DC cable to P1 of
the power supply.
12 Apply power to the pump/dispenser and note the display(s). The first set of numbers displayed
will be the software version (for example, 06013), the second set is the software type (for
example, 9800 1), and the third set is the firmware version (for example, 01008).
Ensure that the displayed software type is correct for the pump/dispenser model that the CPU
is installed in (refer to the following table). If it is, proceed to step
13 . If not, proceed to
“Loading New CPU Software” on page 19 .
Displayed Software Type Corresponding Pump/Dispenser Model
“9800 1” Corresponds to the 9800Q Software:
9852A/Q, 9853A/Q, 9822A/Q, 9823A/Q/K
“9800 2” Corresponds to the 9800K Software:
9852K, 9853K, 9862KX, 9872KX
“9840 1” Corresponds to the 9840Q Software:
9840A, 9840Q
“9840 2” Corresponds to the 9840K Software:
9840K
“9850” Corresponds to all 9850 Software:
9850A, 9850Q, 9850K
13 Reassemble the pump/dispenser by proceeding to “Accessing Electronic Components” on
page 9 and follow the steps in reverse order.