Gasboy 9800 Atlas - Manual (Page 8)

Installation of the Weatherproofing Kit
Page 8 MDE-4687 Weatherproofing Instructions for Atlas™ 9800 Units · August 2007
12 Reinstall the hardware that was removed in steps 5 to 7 .
Note: On electronic units, when reinstalling the Reset Handle Stops, ensure that you adjust the
stop rotation such that the magnetic switches inside the head are properly aligned.
Proper alignment means the magnet switches should be positioned parallel to each
other with a gap of approximately 3/16" (see
Figure 3 on page 6 and Figure 4 on page
6 ). Loctite should be applied to both the cap screws used to install the stops so they do
not vibrate later.
Figure 7: Adjustment of the Reset Handle
Adjust Reset Handle Stop
such that the Magnet
Switches are positioned
parallel to one another, with
approximately 3/16" gap.
Apply Loctite to both the cap
screws to prevent them from
vibrating loose later.
13 If the unit is Dual Hose, repeat steps 1 to 12 for the other side.