Gasboy 9800 Atlas - Manual (Page 7)

MDE-4687 Weatherproofing Instructions for Atlas™ 9800 Units · August 2007 Page 7
Installation of the Weatherproofing Kit
7 Remove the Hose Retriever or Blanking Plate by removing the two nuts inside the frame.
8 Remove the grommet (lubricate the Reset Shaft, if necessary).
9 Raise the top sheathing up slightly and pull the side sheathing away from the frame.
Note: Ensure that you do not bend the side sheathing.
10 Hold the side sheathing away from the frame to reinstall the grommet between the side
sheathing and frame (apply a small amount of lubricant for easy installation of the grommet
over the shaft). Place the larger diameter of the grommet against the frame. See
Figure 5 .
Figure 5: Installation of the Grommet Over the Shaft
11 Carefully relax the side sheathing and fit it over the Reset Shaft and grommet. See Figure 6 .
Figure 6: Reset the Shaft and Grommet