Gasboy 9800 Atlas - Manual (Page 12)

Installation of the Weatherproofing Kit
Page 12 MDE-4687 Weatherproofing Instructions for Atlas™ 9800 Units · August 2007
1 Reinstall both the new bezels using the original fasteners. Ensure that the bezel sits snugly
down on the unit.
Figure 13: Installation of New Bezels
2 Dispose the old bezels properly.
Installation of TopKAT Base Gaskets
To install TopKAT base gaskets, proceed as follows:
1 Lower the dispenser display panel.
2 Disconnect all power and signal lines from inside the TopKAT. Carefully pull these wires back
down into the dispenser head. Ensure that you do not scrape wire insulation or damage
terminations.
3 Remove the bolts inside the TopKAT that hold it to the Mounting Base. Carefully lay the
TopKAT on its side, resting it on a cloth on top of the dispenser.
4 Remove both cross braces from inside the dispenser to expose the TopKAT mounting bolts.
5 Remove TopKAT mounting bolts to free the TopKAT Mounting Base from the dispenser.
6 Remove any old taped Gasket Strips from both sides of the Mounting Base and clean both the
surfaces.
7 Remove the adhesive backing from the TopKAT Mounting Base Gaskets (M07800B001) and
apply one to each side of the Mounting Base. Ensure that you line up the bolt holes on the
gaskets to the bolt holes on the Mounting Base.
8 Reinstall the Mounting Base to the top of the dispenser.