Dish Network Solo 351 - Manual (Page 9)

Chapter 1
Page 4
Introduction
Getting Started
After your system has been installed, order and watch your programming
using the following steps:
Step 1: Ordering Your Programming
1. Using a remote control, press SAT and then press the
blank POWER button. Make sure the TV is also on.
Note : If you see the DISH Network logo displayed on
your TV screen, press the SELECT or blank
POWER button on the remote control to view
satellite TV programming.
2. Press GUIDE.
You will see that some channels in the Program Guide appear
in white. These channels can be viewed immediately. However, many
channels will be in red. You cannot view these channels until you order
programming.
3. Press the SYS INFO button on the remote control to display
the Important System Information screen.
4. Call the Customer Service Center at 1-800-333-DISH (3474). A
customer service representative will help you start DISH Network
programming on your system and will discuss the various programming
packages available.
5. Choose a package and the representative will authorize your
programming.
6. Press SELECT to close the Important System Information screen.
7. Wait a few minutes and the channels you purchased will turn from red to
white, and can now be viewed.
Tip: Remote
Control 1 is used to
control TV1 menus
on the nearby TV.
Remote Control 2
is used to control
TV2 menus on the
remote TV(s).