Dish Network Solo 351 - Manual (Page 21)

Chapter 2
Page 16
Receiver Description and Installation
RCA Out
The RCA audio/video outputs provide high
picture quality and stereo sound to your TV (if
your TV has these connections). These outputs
can be used to provide TV2 menus and
programming to a wireless audio/video transmitter
or to a second input on a nearby TV. Use an RCA-
type cable assembly to make the connection. If the
TV has only one input for this type of audio,
connect it to the right (R) phono (RCA) audio
output on the receiver.
Other Connections
Satellite In
The S ATELLITE I N
connections are used to
receive satellite TV signals from the dish
antenna. The connection is made using
RG-6 coaxial cable. The S ATELLITE I N
connections are color coded blue.
Remote Antenna
The R EMOTE A NTENNA
port receives UHF signals from
the Remote Control 2 so that it can control TV2 menus
from another room. Connect the UHF antenna here,
and place it so that it does not touch anything. If you
do not connect the antenna, you cannot use Remote
Control 2 to control the receiver for TV2 menus and
programming. The R EMOTE A NTENNA
port is color
coded green.
Telephone Jack
The T ELEPHONE J ACK
is used to connect the receiver to an
active telephone line. Use a standard RJ-11 telephone
cable assembly to make the connection.
Remote Controls
The two remote controls give you easy access to all the features of your
satellite receiver. You can set up each remote to control the satellite receiver
and up to three other devices. These devices can be a TV, a VCR or DVD
player, and a third device.