Dish Network Solo 351 - Manual (Page 77)

Chapter 3
Page 72
Using the System
Control Other Devices with the Remote Controls
This section describes how to use Remote Control 1 or Remote Control 2 to
control with a TV, a VCR, or other devices. For information on how to use
the remote to control the receiver, see Using the Remote Controls on page
37. You can set up both remote controls to control the satellite TV receiver
and up three other devices each. These devices can be a TV, a VCR or DVD
player, and a third device.
Where the word “remote” is used in the following section, it applies to both
Remote Control 1 and Remote Control 2.
Remote Control Modes
You can set the remote to four different modes to control the receiver or
other devices. When you get the remote it’s already set up to control the
receiver. You must set up the remote to control a device like a TV or a VCR.
See Set Up the Remote to Control Other Devices, below.
Use the remote control’s mode buttons, SAT (satellite receiver), TV (for a
TV), VCR (for a VCR or a DVD player), and AUX (“auxiliary,” for a second
TV, a second VCR, a tuner, or an audio amplifier) to set the remote to the
right mode for the device. To change the mode, press the button for the
device you want the remote to control. The mode button lights for two
seconds to show you’ve set the remote to that mode.
Limited Mode
You can program your remote control in limited mode to keep from
accidentally changing the channel on your TV or VCR. When you use the
remote to control your TV in limited mode, you will only be able to use the
POWER, MUTE, and VOLUME buttons. Also, when you use the remote to
control your VCR in limited mode, you will only be able to use the power
and VCR function buttons. The section Setting Up the Remote to Control
Other Devices has a step that tells the remote control to go into limited
mode.
Note : You can use Limited Mode for TV and VCR codes programmed in
AUX mode.
Set Up the Remotes to Control Other Devices
Over the next few pages we tell you how to use the remote to control a TV, a
VCR, a DVD player, a tuner, or an amplifier.
To use the remote to control other devices, you must first program it to
control these other devices. You can do this by either following the
instructions in Set Up the Remote Control below, or the Scan for Device
Codes procedure described on page 74.
If you are programming the remote to control a combination device, such as
a TV/VCR or a VCR/DVD, program the remote control in one mode, and
then repeat the procedure in the other mode. For example, to program the
remote to control a TV/VCR using code 748: Follow the instructions to
program the remote to control the TV using code 748, and then repeat the
instructions for the VCR using the same code.
Tip: Remote
Control 1 is used to
control TV1 menus
on the nearby TV.
Remote Control 2
is used to control
TV2 menus on the
remote TV(s).
Tip: Limited mode
is not used with
amplifiers.