Dish Network Solo 351 - Manual (Page 83)

Chapter 3
Page 78
Using the System
Control a VCR (or a Second VCR or a DVD Player)
Only the buttons described here control a VCR or DVD player. Some of the
buttons described here may not control your VCR or DVD player. See the
user’s manual that came with your VCR or DVD player for information
about the features.
VCR Mode Button
You must first set up the remote to control the VCR or DVD player. See Set
Up the Remote to Control Devices, beginning on page 72. Then, you must
press the VCR mode button to set the remote to VCR mode. The VCR mode
button lights for two seconds to show you’ve set the remote to VCR mode.
Make sure you keep the remote in VCR mode to use the buttons described
here.
Note : You can set up the remote to control a second VCR or DVD player in
AUX mode, the same way it controls the first VCR or DVD player in VCR
mode. See Set Up the Remote to Control Devices beginning on page 72.
Note : You must set the remote to VCR mode to set it up to control a DVD
player.
TV/Video Button
Use the TV/VIDEO button to switch the VCR between its TV mode and its
VCR mode (see your VCR user’s manual for information).
Power Button
Press the blank POWER button to turn the VCR on or off.
Page Up and Down Arrow Buttons
Use the PAGE UP and DOWN ARROW buttons to change channels on the
VCR.
Note : If you are using the remote control in limited mode, the VCR will not
change channels.
Recall Button
Press the RECALL button to go back to the last VCR channel you used.
Press it again to switch between the last two VCR channels you used.