Dish Network Solo 351 User Manual
Page 23
Chapter 2
Page 18
Receiver Description and Installation
Batteries
The remote controls come with AAA batteries, which need to be installed
when you first receive your system. When you replace old batteries, you
should replace all of the batteries. Use batteries of the same kind, for
example alkaline or carbon zinc, and don’t mix batteries of different kinds.
Alkaline batteries last longer than carbon zinc.
Installing or Changing the Batteries
1. Press down on the battery cover’s top latch and slide the
cover off.
2. If you are changing out batteries, take out all of the old
batteries.
3. Put the new batteries in. Make sure you match the plus
(“+”) ends with the plus markings on the battery case.
4. Slide the cover back into place.
Low Battery Warning
When you see a low battery warning message below the
Program Banner
,
the batteries in your remote control are weak and need to be replaced.
Attach a UHF Antenna
You need to attach the UHF remote antenna to the
receiver’s back panel
R
EMOTE
A
NTENNA
input so
you can use UHF Pro Remote Control 2.
Note
: Be sure to set the antenna straight up so you can use the remote
control from as far away as possible. Don’t let the antenna touch anything.