Dish Network Solo 351 - Manual (Page 78)

Page 73
Control Other Devices with the Remote Controls
Set Up the Remote Control
1. Turn the device on. Use the device’s front panel buttons
or its remote control.
2. Find the brand name of the
device in the tables starting on
page 113.
If the brand isn’t listed, see Scan for
Device Codes on page 74.
3. Press and hold the mode
button until all the other mode
buttons light up, and then let
go of the button.
The mode button flashes.
If you are repeating this
procedure to program a
combination device, be sure to
press the correct mode button
(for example, if you have a
TV/VCR combination and
you have already programmed
the remote to control the TV,
press and hold the VCR mode
button as described above).
For example, hold the TV mode
button for a TV until all of the other
mode buttons light. When you let
go, the TV mode light will flash.
4. For AUX mode only:
• Press 0 for a second TV.
• Press 1 for a second VCR
or DVD player.
• Press 2 - for a tuner or
amplifier.
This step is for programming which
kind of device that should be
programmed in AUX mode. If
you’re not programming in AUX
mode, skip to step 5.
5. Enter one of the three-digit
device codes from the table
using the number buttons.
The three-digit device code should
be for the brand name of your device
that you found in step 2.
6. If you want to program
limited mode, press 1. If not,
skip to step 7.
See Limited Mode for more
information.
7. Press the POUND (#) button. If you entered the code correctly, the
mode button flashes three times.
8. Press the blank POWER
button to turn off the device. If
the device does not turn off,
go to step 10.
If the code works, the device should
turn off.