Dish Network Solo 351 - Manual (Page 75)

Chapter 3
Page 70
Using the System
Turning Caller ID On and Off
1. Press MENU on the remote control.
2. Select System Setup .
3. Select Installation .
4. Select Caller ID .
5. Select Enable Caller ID or select Disable Caller ID .
6. Select Done .
Resetting to Factory Default Settings
Note : Resetting the receiver to factory default settings discards all Favorite
Lists except the All Chan and All Sub lists.
Note : If you have set any locks on the receiver, and the receiver is locked,
these locks will be kept. If the receiver is unlocked, any such locks will be
lost; however, you cannot reset the receiver to factory default settings to
bypass a lock or to discard a password you have forgotten. Call the Customer
Service Center if you have forgotten your password.
Complete the following instructions if you want to reset the receiver to be
the same as when it was shipped from the factory.
1. Press the MENU button.
2. Select the System Setup option.