Dish Network Solo 351 - Manual (Page 35)

Chapter 2
Page 30
Receiver Description and Installation
6. Make sure that the information on the Installation Summary screen
identifies your system correctly and shows all transponders for all
satellites in your system. Your screen may look different from the
example above depending on the dish antenna system you are using.
7. Select OK to go to the Point Dish/Signal screen.
8. Select Cancel to exit the Point Dish menu. An Attention screen will
open asking if the mounting and positioning of your dish is complete
with a Locked indication in the Point Dish screen. If the answer is yes,
select Yes.
If the answer is No, you will need to repoint your dish following the
preceding steps until the mounting and positioning is complete and you
do have the Locked indication.
9. After you select Yes, the receiver will begin taking a software upgrade.
You will see a Warning that Vital program information will now be
downloaded into your receiver . You will also see a status bar showing
the progress of this upgrade.
10. Once the software upgrade is complete, you will see a message that your
receiver’s memory is being upgraded.
11. Do not disturb the receiver while the receiver’s memory is being
upgraded.
Note : If you are installing other DISH Pro or DISH Pro Plus receivers,
be sure to run Check Switch on all of them, and allow them to take the
necessary software upgrade.
12. When the memory upgrade is complete, you should be watching TV.
Your dish antenna installation is now complete.