Setting up tv1 to operate in ir – Dish Network Solo 351 User Manual

Page 40

Page 35

Setting Up TV1 to Operate in IR

c. Press the POUND (#) button. If you entered the address correctly,

the SAT mode button will flash three times.

d. Press the RECORD button.

e. Make sure the

System Information

screen shows that the

Primary

Remote Address

shows

UHF Pro and IR

and that this address

matches the number you entered in step b.

Setting Up TV1 to Operate in IR

The following instructions describe how to set up TV1 to operate in IR only.

1. Perform the following with an existing remote control:

a. Open the

TV1 UHF Pro Setup

screen by pressing MENU-6-1-8 on

the remote control.

b. Select

Disable

from the

TV1 UHF Pro Setup

screen.

c. Select

System Info

to open the

System Information

screen.

2. Using an IR remote control, such as a Remote Control 3.0, that you

intend to use to control TV1:

a. Press the RECORD button. The

Done

button should be

highlighted.

b. Make sure the

System Information

screen shows that the

Primary

Remote Address

shows