Foxconn 865A01-PE-6EKRS - Manual (Page 87)

79
865A01 G/PE User Manual
Chapter 4 Driver CD Introduction
Description: all Line Out, Line In and Microphone functions exist in 2-
channel mode.
4-Channel Analog Audio Interface
Description: in the 4-channel setting, Line In is changed to Line Out function.
2-Channel Analog Audio Interface
2).Use 4-/6- Channel Audio Functions
After installing the driver, you can use the 4-/6- channel functions. First,
connect 4 or 6 speakers corresponding to the audio interfaces and then
select the 4 or 6 audio settings in the software.
Connect Audio Box
In order to use the multi-channel function, you must connect several
speakers to the system. You must connect the same number of speakers
as channels selected in the software. The audio interface on the rear
panel can only support 2-channel analog
audio output function. When
you select the correct settings in the software, the audio interface on the
rear panel automatically changes into a 4-/6- channel analog audio
interface. Please refer to “How to Select 4- or 6- Channel Setting” at the
end of this chapter for more setting information.
Ensure all speakers are connected to the Line Out interfaces. Use the
interface on the rear panel to use 2-, 4- and 6- channel configuration,
described as follows.
Line Out (front channels)
Line In
Microphone
Line Out (front channels)
Line Out (rear channels)
Microphone
865A01-FOXCONN-V1.3-EN-121603.p65 2004-5-27, 18:03 79