Foxconn 865A01-PE-6EKRS - Manual (Page 37)

29
Chapter 2 Installation Instructions
865A01 G/PE User Manual
1394 Header: 1394 HDER (Optional)
The 1394 expansion cable can be connected to either the front (provided that
the front panel of your chassis is equipped with the appropriate interface) or
real panel of the chassis.
Wake-up On LAN: WOL
Through the Wake-Up On LAN function, a wake event occurring from the
network can wake up the system. To utilize this function, please be sure to
use an ATX 12V power supply with a 5VSB line capable of delivering a current
of at least 720mA, and a LAN adapter which supports this function. Then
connect the header to the relevant connector on the LAN adapter, set “Wake
up by PCI Card” to enabled in the “POWER MANAGEMENT SETUP” section
of the CMOS SETUP. Save and exit, then boot the operating system once to
make sure this function takes effect.
1394 Header2
TB1+
TA1+
CON_PWR
NC
GND
TB1-
CON_PWR
GND
GND
TA1-
1 2
9 10
WOL
PMEJ
5V_SB_SYS
GND 1
865A01-FOXCONN-V1.3-EN-121603.p65 2004-5-27, 18:02 29