Foxconn 865A01-PE-6EKRS - Manual (Page 32)

24
Chapter 2 Installation Instructions
865A01 G/PE User Manual
Other Connectors
This motherboard includes interfaces for FDD, IDE HDD, SATA, USB, 1394,
IR module, CPU/system fan, and others.
FDD
This motherboard includes a standard FDD interface, supporting 360K, 720K,
1.2M, 1.44M, and 2.88M FDDs.
FDD Interface
HDD connectors: PIDE & SIDE
These connectors support the provided UltraDMA 100/66/33 IDE hard disk
ribbon cable. Connect the cable’s blue connector to the primary
(recommended) or secondary IDE connector, then connect the gray connec-
tor to the Ultra DMA 100/66/33 slave device (hard disk drive) and the black
connector to the Ultra DMA 100/66/33 master device. If you install two hard
disks, you must configure the second drive as a slave device by setting its
jumper accordingly. Refer to the hard disk documentation for the jumper
settings.
Attention:
Ribbon cables are directional, therefore, make sure to always
connect with the cable on the same side as pin 1 of the PIDE/
SIDE or FDD connector on the motherboard.
865A01-FOXCONN-V1.3-EN-121603.p65 2004-5-27, 18:02 24