Foxconn 865A01-PE-6EKRS - Manual (Page 27)

19
Chapter 2 Installation Instructions
865A01 G/PE User Manual
4. Make sure that the memory frequency matches the CPU FSB (Front Side
Bus). Refer to the following table.
5. DIMMs installed into any three sockets will function in single Channel
mode.
6. When all four sockets are populated with 1GB DIMMs (total 4GB), the
system may detect over 3GB (a little less than 4GB) to ICH5R resource
allocation.
7. Double-sided DDR DIMMs with X16 (databus width=16-bit) memory chips
are not supported due to chipset limitations.
8. lt is recommended to use the yellow DIMM slots first.
CPU FSB DDR DIMM Type Memory Frequency
800 MHz PC3200/PC2700/PC2100 400/333/266 MHz
533 MHz PC2700/PC2100 333/266 MHz
400 MHz PC2100 266 MHz
Note:
1. When using 800MHz CPU FSB,PC2700DDR DIMMs may
run only at 320MHz(not 333MHz) due to chipset limitation.
2.The following FSB/DDR ratios are not supported:400/333,
400/400,533/400.
3. FSB/DDR setting 800/333 is recognized as FSB/DDR 800/
320.
865A01-FOXCONN-V1.3-EN-121603.p65 2004-5-27, 18:02 19