Foxconn 865A01-PE-6EKRS - Manual (Page 39)

31
Chapter 2 Installation Instructions
865A01 G/PE User Manual
S-ATA Connectors: CN21, CN22
The S-ATA header is used to connect the S-ATA device to the motherboard.
These connectors support the thin Serial ATA cables for primary internal
storage devices. The current Serial ATA interface allows up to 150MB/s data
transfer rate, faster than the standard parallel ATA with 133MB/s (Ultra ATA/
133).
SATA1/SATA2
GND
GND
GND
RX+
RX-
TX+
TX-
Serial ATA solution:
1. In legacy operating system (Win98, WinME, WinNT, DOS) enviromemt,
using Serial ATA will disable one of the IDE channels from ICH5R south
bridge chipset. See the BIOS section for correct settings.
2. The Serial ATA cable is smaller and more flexible allowing easier routing
inside the chassis. The lower pin count of the Serial ATA cable eliminates
the problem caused by the wide, flat ribbon cables of the Parallel ATA
interface.
3. The IAA-RAID driver is available for WinXP/2000 only.
4. RAID 0 and RAID 1 are supported.
5. Install WinXP Service Pack1 when using Serial ATA.
865A01-FOXCONN-V1.3-EN-121603.p65 2004-5-27, 18:02 31