Foxconn 865A01-PE-6EKRS - Manual (Page 14)

Chapter 1 Product Introduction
6
865A01 G/PE User Manual
ATX 12V connector
This power connector connects the 4-pin 12V plug from the ATX 12V power
supply.
CPU socket
A 478-pin surface mount, Zero Insertion Force (ZIF) Socket for the intel ®
Pentium ® 4 processor (and Intel’s future Prescott CPU) Supports 800/533/
400 MHz system bus and allows up to 6.4GB/s data transfer rates.
North bridge controller
The Intel ® 865G Graphics Memory Controller Hub(GMCH) and the Intel ® 865PE
Memory Controller Hub(MCH) provide the processor interface with 800/533/
400 MHz frequency, system memory interface at 400/333/266MHz operation,
and 1.5V AGP interface that supports AGP 3.0 specification including 8X Fast
Write protocol, the GMCH provides an integrated graphics accelerator.
DDR DIMM sockets
These four 184-pin DIMM sockets support up to 4GB system memory using
unbuffered non-ECC PC3200/2700/2100 DDR DIMMs.
Super I/O
The Winbond W83627HF Low Pin Count (LPC) interface provides the
commonly used Super I/O functionality. The chip supports a high-performance
floppy disk controller for a 360k/720K/1.44M/2.88M floppy disk drive, a multi-
mode parallel port, two serial ports, the mouse and keyboard interface and
the LPC (Low Pin Count) interface.
ATX power connector
This 20-pin connector connects to an ATX power supply. The power supply
must have at least 1A on the +5V standby lead (+5VSB).
IDE connectors
These 2-channel bus master IDE connectors support Ultra DMA 100/66/33,
PIO Modes 3 & 4 IDE devices. Both the primary (blue)and secondary (white)
connectors are slotted to prevent incorrect insertion of the IDE ribbon cable.
1
2
3
4
5
6
7
865A01-FOXCONN-V1.3-EN-121603.p65 2004-5-27, 18:02 6