Formax 7102/7102XT Series - Manual (Page 93)

475mm (18.7”) Width:
700mm (27.6”) Height:
25Kg (55lbs) Weight:
Processing Speed
4500 filled envelopes per hour.
6HULHV:
5500 filled envelopes per hour.
;76HULHV:
Ambient light:
Although the machine may operate in sunlight, it is not designed for use in direct sunlight,
or where sunlight is exposed to the machine through windows or skylights. The light-sensitive
sensors can be affected in these conditions. It is therefore recommended to:
1. Locate the machine out of direct sunlight
2. Protect the machine from direct sunlight using blinds or similar blocking devices.
If the machine can only be located where it may be exposed to direct sunlight, then please
contact Technical Support department, who may be able to advise on the use of blocking
material on the inside of the Perspex cover where necessary.
1. All stationery should be allowed to acclimatise near the
machine for at least 24 hours before use to prevent rapid
absorption of moisture in the material, or condensation forming
on the machine. Failure to acclimatise the material may cause
pre-gumming of envelopes or otherwise impair machine
performance.
2. The machine will function with humidity levels lower than 30%
RH, but high levels of static may be generated, impairing
machine performance.
3. The machine will function with humidity levels higher than 80%
RH, but moisture absorption into the material may impair
machine performance.
4. Condensation must not be present under any circumstances.
5. The machine will function at temperature levels above 28 deg
C (82 deg F) and below 18 deg C (64 deg F). However,
temperature levels outside these limits may impair the machine
performance.
6. Material processed directly from laser printers may have high
levels of static causing material to stick together. If double
feeding occurs, then Hi-Grip separators may be required -
contact IPSS department.
90
| Page 90 | aug-29-2014 10:01 | Technical Specification
10
English