Formax 7102/7102XT Series - Manual (Page 42)

4. Choose whether to collate leading edges of documents as they feed through the folder,
then folded together without entering the accumulator, or to feed separately into the
accumulator before folding. Sheets are fed singly by default, so each sheet is folded
and inserted separately. Set max number for folding together. Groups bigger than this
will be split into a) max number, followed by b) remainder.
The maximum that can be fed into the accumulator defaults to 9 (Max. collate), but
can be up to 25.
This will depend upon the paper type.
Multi-envelope mode allows two separate jobs to be run in succession using the same
document set. If set to ‘Split Oversize’, this splits, folds and inserts as for ‘Max Fold’
described above. If set to ‘Divert Oversize’, all groups numbering greater than the
number set in ‘Divert/Split Threshold’ will be diverted to the divert tray, and if set to
‘Divert Undersize’, the same will apply for groups below the threshold.
The machine is then stopped, the job is changed and the forms in the divert tray are
put back into the document set, and the new job is run.
‘Divert Action’ allows the option of the machine stopping automatically upon divert, or
to continue, allowing the operator to intervene.
When you have finished, fold settings are now complete and the screen will show that
this is ticked.See also Table 1 on the following page.
Table 1
Handling of folded forms
Shown below are handling of oversized/undersized groups under different
circumstances.
7
English
39
| Page 39 | aug-29-2014 10:01 | Creating a job