Formax 7102/7102XT Series - Manual (Page 18)

2. Select Hardware Fine Tuning to display further information.
You can change:
- The width of the collate pocket guides.
- The overall width of the insert fingers.
- The time allowed for the flap to seal before the envelope is ejected.
- Adjustment of the point at which the wetter beam drops to wet the flap. +ve
increases wetting in 1mm steps (moves start point towards insertion area).
- Adjustment of the amount of envelope travel into the sealing rollers. +ve = further
forward, away from exit direction.
- Adjustment of the envelope stop position for insertion. +ve = further forwards,
towards exit direction.
- Adjustment of the amount of insertion of the insert pack into the envelope. +ve
= further forwards past the flap crease.
- Adjustment of the amount of envelope forward travel after flap wetting, before
reversing to enter the sealing rollers. +ve = further forward into the output rollers,
towards the exit direction. for high-window envelopes, this should be set to
20 - 50mm +ve.
- Adjustment of inserter head speed. Set a lower speed if insert packs are not
being fully inserted, eg. for long packs.
- Control of blower fan which assists envelope opening. Increase to open envelope
more, eg. for thick packs, decrease for single sheets or thin packs.
- Changing finger sequence if envelopes are not opening properly. Try other
settings if this is the case.
- Adjustment of number of envelopes that will feed before the detection flags
switches the conveyor back on after it has stopped. Increase number if envelopes
are ‘bunching’.
- Adjustment of degree of pause of the insertion pawls after inserting pack.
Increase if pawls start moving too soon and contacting inserted pack before it
has moved towards closer.
- Control of the overlap of sealed packs on the output conveyor. Higher number
will increase conveyor speed and reduce overlap.
- Collate Slowdown: Select ‘Not on Last Form’ for thick packs if the final document
in the pack does not feed fully into the collate pocket.
4
English
15
| Page 15 | aug-29-2014 10:01 | Control Panel