DFI DT122-CR Manual - Manual (Page 66)

www.dfi .com
66
Chapter 8 Supported Software
Chapter 8
4. Click “Install” to begin the
installation.
5. After completing installa-
tion, click “Finish”.
3. Enter “User name” (SB102)
and “Organization” information
then click “Next”. MyGuard Hardware Monitor
To install the driver, click “MyGuard Hardware Monitor” on the main menu.
1. Setup is ready to install the
utility. Click Next.
2. Click Install to begin instal-
lation.
3. Setup is currently installing
the utility.