DFI DT122-CR Manual - Manual (Page 24)

www.dfi .com
24
Chapter 5 Ports and Connectors
Chapter 5
RJ45 LAN Ports
The LAN ports allow the system board to connect to a local area network by means of a net-
work hub.
BIOS Setting
Configure the onboard LAN in the Chipset menu (“South Bridge Configuration” submenu) of
the BIOS. Refer to chapter 7 for more information.
Driver Installation
Install the LAN drivers. Refer to chapter 8 for more information.
Features
DVI-I Port
The DVI-I port is used to connect an LCD monitor. This port supports DVI-D signal only.
Connect the display device’s cable connector to the DVI-I port. After you plug the cable con-
nector into the port, gently tighten the cable screws to hold the connector in place.
BIOS Setting
Configure the display device in the Chipset menu (“North Bridge Configuration” submenu) of
the BIOS. Refer to chapter 3 for more information.
LAN 1
LAN 2
• Intel 82579LM with iAMT8.0 Gigabit LAN Phy
• Intel 82574L PCI Express Gigabit LAN controller