DFI DT122-CR Manual - Manual (Page 40)

www.dfi .com
40
Chapter 7 BIOS Setup
Chapter 7
If AHCI or RAID is selected in the SATA Mode Selection, it will display the follow-
ing information:
Determines how SATA
controller(s) operate.
Aptio Setup Utility - Copyright (C) 2011 American Megatrends, Inc.
Version 2.14.1219. Copyright (C) 2011 American Megatrends, Inc.
SATA Controller(s)
SATA Mode Selection
SATA Test Mode
Agressive LPM Support
Software Feature Mask Confi guration
Serial ATA Port 0
Software Preserve
Port 0
Hot Plug
External SATA
SATA Device Type
Spin Up Device
Serial ATA Port 1
Software Preserve
Port 1
Hot Plug
External SATA
SATA Device Type
Spin Up Device
Serial ATA Port 4
Software Preserve
Port 4
Hot Plug
External SATA
Advanced
Serial ATA Port 0 to Serial ATA Port 5
These fields are used to configure the connected SATA devices.
[Enabled]
[AHCI]
[Disabled]
[Enabled]
Hitachi HDT721 (1000.
Supported
[Enabled]
[Disabled]
[Disabled]
[Hard Disk Driver]
[Disabled]
Hitachi HDS 722 (2000.
Supported
[Enabled]
[Disabled]
[Disabled]
[Hard Disk Driver]
[Disabled]
Empty
Unknown
[Enabled]
[Disabled]
[Disabled]
 Select Screen
 Select Item
Enter: Select
+/-: Change Opt.
F1: General Help
F2: Previous
Values
F3: Optimized Defaults
ESC: Exit
Software Feature Mask Configuration
Aptio Setup Utility - Copyright (C) 2011 American Megatrends, Inc.
Version 2.14.1219. Copyright (C) 2011 American Megatrends, Inc.
RAID0
RAID1
RAID10
RAID5
Intel Rapid Recovery Technology
OROM UI and BANNER
HDD Unlock
LED Locate
IRRT only on eSATA
Smart Response Technology
OROM UI Delay
Advanced
[Enabled]
[Enabled]
[Enabled]
[Enabled]
[Enabled]
[Enabled]
[Enabled]
[Enabled]
[Enabled]
[Enabled]
[2 Seconds]
 Select Screen
 Select Item
Enter: Select
+/-: Change Opt.
F1: General Help
F2: Previous
Values
F3: Optimized Defaults
ESC: Exit
Enable or disable RAID0
feature.
RAID0 to RAID5
Enables or disables RAID0 to RAID5 feature.
Intel Rapid Recovery Technology
Enables or disables Intel Rapid Recovery Technology.
OROM UI and BANNER
When enabled, the OROM UI is shown. When disabled, no OROM banner or
information will be displayed if all disks and RAID volumes are Normal.
HDD Unlock
When enabled, it indicates that the HDD password unlock in the OS is ena-
bled.
LED Locate
When enabled, it indicates that the LED/SGPIO hardware is attached and
ping to locate feature is enabled on the OS.
IRRT only on eSATA
When enabled, only IRRT volumes can span internal and eSATA drives.
When disabled, any RAID volume can span internal and eSATA drives.