DFI DT122-CR Manual - Manual (Page 45)

www.dfi .com
45
Chapter 7 BIOS Setup
Chapter 7
Enable or Disable Serial
Port (COM)
Aptio Setup Utility - Copyright (C) 2011 American Megatrends, Inc.
Version 2.14.1219. Copyright (C) 2011 American Megatrends, Inc.
Serial Port 1 Confi guration
Serial Port
Device Settings
Change Settings
Advanced
[Enabled]
IO=3F8h; IRQ=4;
[Auto]
Serial Port 1 Configuration to Serial Port 2 Configuration
 Select Screen
 Select Item
Enter: Select
+/-: Change Opt.
F1: General Help
F2: Previous
Values
F3: Optimized Defaults
ESC: Exit
Serial Port
Enables or disables the serial port.
Change Settings
Selects the IO/IRQ setting of the I/O device.
Device Mode
Enable or disable serial port (COM)
Enable or Disable Serial
Port (COM)
Aptio Setup Utility - Copyright (C) 2011 American Megatrends, Inc.
Version 2.14.1219. Copyright (C) 2011 American Megatrends, Inc.
Serial Port 2 Confi guration
Serial Port
Device Settings
Change Settings
Device Mode
Advanced
[Enabled]
IO=2F8h; IRQ=3;
[Auto]
[Serial Port Funct...]
 Select Screen
 Select Item
Enter: Select
+/-: Change Opt.
F1: General Help
F2: Previous
Values
F3: Optimized Defaults
ESC: Exit
Serial Port Console Redirection
Console Redirection En-
able or Disable.
Aptio Setup Utility - Copyright (C) 2011 American Megatrends, Inc.
Version 2.14.1219. Copyright (C) 2011 American Megatrends, Inc.
COM1 (Disabled)
Console Redirection
COM2 (Pci Bus0, Dev0, Func0) (Disabled)
Console Redirection
Serial Port for Out-of-Band Management/
Windows Emergency Management Service (EMS)
Console Redirection
 Console Redirection Settings
Advanced
Port is Disabled
Port is Disabled
[Disabled]
 Select Screen
 Select Item
Enter: Select
+/-: Change Opt.
F1: General Help
F2: Previous
Values
F3: Optimized Defaults
ESC: Exit
Console Redirection Settings
The settings specify how the host computer and the remote computer (which the user is
using) will exchange data. Both computers should have the same or the compatible set-
tings.