Chapter 7 – DFI DT122-CR Manual User Manual
Page 48
www.dfi .com
48
Chapter 7 BIOS Setup
Chapter 7
xHCI Mode
Mode of operation of xHCI controller. Options are Smart Auto, Auto, Enabled,
Disabled.
EHCI1 and EHCI2
These fields are used to enable or disable USB 2.0.
PCH Azalia Configuration
Azalia internal HDMI codec
Enables or disables the Azalia internal HDMI codec.
Control detection of the
Azalia device.
Disable= Azalia will be
unconditionally disabled
Enabled= Azalia will be
unconditionally enabled
Auto=Azalia will be ena-
bled if present, disabled
otherwise.
Aptio Setup Utility - Copyright (C) 2011 American Megatrends, Inc.
Version 2.14.1219. Copyright (C) 2011 American Megatrends, Inc.
PCH Azalia Confi guration
Azalia
Azalia Internal HDMI Codec
Azalia HDMI Code Port B
[Auto]
[Enabled]
[Enabled]
Chipset
Select Screen
Select Item
Enter: Select
+/-: Change Opt.
F1: General Help
F2: Previous
Values
F3: Optimized
Defaults
ESC: Exit
System Agent (SA) Configuration
Confi g Graphics Settings.
Aptio Setup Utility - Copyright (C) 2011 American Megatrends, Inc.
Version 2.14.1219. Copyright (C) 2011 American Megatrends, Inc.
System Agent Bridge Name
System Agent RC Version
VT-d Capability
Graphics Confi guration
NB PCIe Confi guration
Memory Confi guration
IvyBridge
1.0.0.1
Supported
Primary Display
Auto
When the system boots, it will auto detects the display de-
vice.
IGFX
When the system boots, it will fi rst initialize the onboard
VGA.
PEG
When the system boots, it will fi rst initialize the PCI Express
x16 graphics card.
Chipset
Select Screen
Select Item
Enter: Select
+/-: Change Opt.
F1: General Help
F2: Previous
Values
F3: Optimized
Defaults
ESC: Exit
Graphics Configuration
Select DVMT5.0 Total
Graphic Memory size used
by the Internal Graphics
Device.
Aptio Setup Utility - Copyright (C) 2011 American Megatrends, Inc.
Version 2.14.1219. Copyright (C) 2011 American Megatrends, Inc.
Graphics Confi guration
IGFx VBIOS Version
IGfx Frequency
Primary Display
DVMT Total Gfx Mem
LCD Control
2120
350 MHz
[Auto]
[256M]
Chipset
Select Screen
Select Item
Enter: Select
+/-: Change Opt.
F1: General Help
F2: Previous
Values
F3: Optimized
Defaults
ESC: Exit