DFI DT122-CR Manual - Manual (Page 37)

www.dfi .com
37
Chapter 7 BIOS Setup
Chapter 7
ACPI Power Management Configuration
This section is used to configure the ACPI Power Management.
ACPI Sleep State
Selects the highest ACPI sleep state the system will enter when the Suspend
button is pressed.
S1(POS) Enables the Power On Suspend function.
S3(STR) Enables the Suspend to RAM function.
Resume by PME
Enable this field to use the PME signal to wake up the system.
Resume by RTC Alarm
When Enabled, the system uses the RTC to generate a wakeup event.
Enables or Disables BIOS
ACPI Auto Confi guration.
Aptio Setup Utility - Copyright (C) 2011 American Megatrends, Inc.
Version 2.14.1219. Copyright (C) 2011 American Megatrends, Inc.
ACPI Power Management Confi guration
Enable ACPI Auto Confi guration
ACPI Sleep State
Resume by PME
Resume by RTC Alarm
Advanced
[Disable]
[S3 (Suspend to RAM) ]
[Disabled]
[Disabled]
 Select Screen
 Select Item
Enter: Select
+/-: Change Opt.
F1: General Help
F2: Previous
Values
F3: Optimized Defaults
ESC: Exit
Trusted Computing (optional)
This section configures settings relevant to Trusted Computing innovations.
Enables or Disables
BIOS support for security
device. O.S. will not show
Security Device. TCG
EFI protocol and INT1A
interface will not be
available.
Aptio Setup Utility - Copyright (C) 2011 American Megatrends, Inc.
Version 2.14.1219. Copyright (C) 2011 American Megatrends, Inc.
Confi guration
TPM Support
Current Status Information
Advanced
TPM Support
Enables or Disables TPM. O.S. will not show TPM. Resetting the platform is required.
[Disabled]
 Select Screen
 Select Item
Enter: Select
+/-: Change Opt.
F1: General Help
F2: Previous
Values
F3: Optimized Defaults
ESC: Exit