Chapter 7, Boot – DFI DT122-CR Manual User Manual
Page 50
www.dfi .com
50
Chapter 7 BIOS Setup
Chapter 7
Memory Configuration
Aptio Setup Utility - Copyright (C) 2011 American Megatrends, Inc.
Version 2.14.1219. Copyright (C) 2011 American Megatrends, Inc.
Memory Information
Memory RC Version
Memory Frequency
Total Memory
DIMM#1
DIMM#2
CAS Latency (tCL)
Minimum delay time
CAS to RAS (tRCDmin)
Row Precharge (tRPmin)
Active to Precharge (tRASmin)
1.0.0.0
1600 Mhz
8192 MB (DDR3)
4096 MB (DDR3)
4096 MB (DDR3)
11
11
11
28
Chipset
Select Screen
Select Item
Enter: Select
+/-: Change Opt.
F1: General Help
F2: Previous
Values
F3: Optimized
Defaults
ESC: Exit
Setup Prompt Timeout
Selects the number of seconds to wait for the setup activation key. 65535(0xFFFF) denotes
indefinite waiting.
Bootup NumLock State
This allows you to determine the default state of the numeric keypad. By default, the sys-
tem boots up with NumLock on wherein the function of the numeric keypad is the number
keys. When set to Off, the function of the numeric keypad is the arrow keys.
Quiet Boot
Enables or disables the quiet boot function.
Fast Boot
Enables or disables boot with initialization of a minimal set of devices re
quired to launch active boot option. Has no effect for BBS boot options.
GateA20 Active
Upon Request- GA20 can be disabled using BIOS services.
Always- Do not allow disabling GA20; this option is useful when any RT code is executed
above 1MB.
Boot
Number of seconds to
wait for setup activation
key.
65535(0xFFFF) means
indefi nite waiting.
Aptio Setup Utility - Copyright (C) 2011 American Megatrends, Inc.
Version 2.14.1219. Copyright (C) 2011 American Megatrends, Inc.
Boot Confi guration
Setup Prompt Timeout
Bootup NumLock State
Quiet Boot
Fast Boot
CSM16 Module Version
GateA20 Active
Option ROM Messages
Interrupt 19 Capture
Boot Option Priorities
Boot Option #1
Boot Option #2
CD/ DVD ROM Driver BBS Priorities
Hard Driver BBS Priorities
CSM Parameters
Save & Exit
Chipset
Advanced
Security
Main
Boot
Select Screen
Select Item
Enter: Select
+/-: Change Opt.
F1: General Help
F2: Previous
Values
F3: Optimized
Defaults
ESC: Exit
1
[On]
[Disabled]
[Disabled]
07.69
[Upon Request]
[Force BIOS]
[Immediate]
[P5: ATAPI iHAS32...]
[PO0: WDC WD6402AAEX...]