DFI ST101-CP - Manual

1/9
1. Make sure the system and all other peripheral devices connected to it has been
powered-off.
2. Disconnect all power cords and cables.
ST101-CP
Installation Guide
Removing the Chassis Cover
3. The screw at the rear panel is
used to secure the cover to the
chassis. Remove the cover screw
then put it in a safe place for later
use.
4 Lift the cover by first pulling it
backward (1) then lifting it up (2).
Side view
X
(2)
X
(1)
1. The drive bay bracket is readily
accessible when you remove the
cover.
Removing the Drive Bay Bracket
Drive bay
bracket