DFI DT122-CR Manual - Manual (Page 22)

www.dfi .com
22
Chapter 5 Ports and Connectors
Chapter 5
Chapter 5 - Ports and Connectors
Bottom Panel I/O Ports PS/2 Mouse/Keyboard
These ports are used to connect a PS/2 mouse and a PS/2 keyboard. The PS/2 mouse port
uses IRQ12.
Wake-On-PS/2 Keyboard/Mouse
The Wake-On-PS/2 Keyboard/Mouse function allows you to use the PS/2 keyboard or PS/2
mouse to power-on the system. To use this function:
• Jumper Setting
JP2 must be set to “2-3 On: +5V_standby”. Refer to “PS/2 Power Select” in this chapter for
more information .
• BIOS Setting
Configure the PS/2 keyboard/mouse wake up function in the Advanced menu (“ACPI Power
Management Configuration” submenu) of the BIOS. Refer to chapter 7 for more information.
Important:
The +5V_standby power source of your power supply must support ≥720mA.
Mic-in/Center+Subwoofer
COM 1
Line-in/Surround Line-out
DVI-I
HDMI
USB 2.0
PS/2 Mouse/KB
DVI-I
(DVI-D signal)
LAN 1-2
USB 3.0
The rear panel I/O ports consist of the following:
• PS/2 mouse/keyboard port
• COM port
• DVI-I port
• DVI-I port (DVI-D signal only)
• 2 Intel LAN ports
• 4 USB ports
• Line-out jack
• Line-in jack
• Mic-in jack
PS/2
Mouse/Keyboard