DFI DT122-CR Manual - Manual (Page 29)

www.dfi .com
29
Chapter 5 Ports and Connectors
Chapter 5
SATA 0
The Serial ATA connectors are used to connect Serial ATA devices. Connect one end of the Serial
ATA cable to a SATA connector and the other end to your Serial ATA device.
BIOS Setting
Confi gure the Serial ATA drives in the Advanced menu (“IDE Confi guration” submenu) of the BIOS.
Refer to chapter 7 for more information.
SATA (Serial ATA) Connectors
7
RXN GND TXP TXN GND
1
RXP GND
SATA 2.0 3Gb/s
SATA 3.0 6Gb/s
• 4 Serial ATA ports
- 2 SATA2 ports with data transfer rate up to 3Gb/s
- 2 SATA3 ports with data transfer rate up to 6Gb/s
• Integrated Advanced Host Controller Interface (AHCI) controller
• Supports RAID 0, RAID 1, RAID 5 and RAID 10
SATA 1
SATA 4
SATA 5
Cooling Fan Connectors
The fan connectors are used to connect cooling fans. The cooling fans will provide adequate
airflow throughout the chassis to prevent overheating the CPU and system board components.
BIOS Setting
The Advanced menu (“Hardware Health Configuration” submenu) of the BIOS will display the
current speed of the cooling fans. Refer to chapter 3 for more information.
System fan
CPU fan
1
3 Sense
Power
Ground
3
1 Ground
Power
Sense
Features