Cybex 55620H Modular User Manual
Page 96
8. Install Weight Plate Decal and Half Weight
(see steps 9A - 9H, Figures 19 and 20).
A. Locate the weight plate decals.
B. Place weight plate decals on weight plates
according to steps listed below and Figures
18 and 19.
C. Slowly and carefully peel off back side of
decal. NOTE: When peeling off back cover,
make sure that the decals remain attached to
the front sticker.
D. Align holes in decal with appropriate holes in
weight stack. NOTE: Do not allow the
adhesive to touch weight stack at this time.
E. Insert a guide pin through each hole of the
template. NOTE: A guide pin can be any-
thing that fits through the weight stack hole,
such as a weight stack selector pin.
F. Carefully align decal and rub it onto weight
plates.
G. Carefully remove front side, leaving decals
adhering to weight plates. See Figure 19.
H. Locate half weight and install it on the half weight peg.
10. Install the back and seat cushions (see steps 10A - 10I and Figures 20 - 21).
A. Locate the cushion box and verify the contents as shown in Figure 20.
Figure 18
Decal
Weight Stack
Guide Rod
Figure 19
Figure 20
36
37
11
33
Cybex Modular Owner’s Manual
Page 4-42