Cybex 55620H Modular - Manual (Page 64)

3. Unpack the carton containing the column (see steps 3A - 3I and Figures 3 - 8).
A. Locate and open the Leg Press Column carton.
B. The column should be laying so that the back side is facing upward.
C. For Free Standing units containing a back cover, remove the pin (#83) securing the back
cover (#66). Remove back cover by sliding it then lifting it upward. See Figure 3.
Figure 3
D. Remove the shipping supports securing the pulley mount and two hardware packs located
inside the column.
E. Verify contents of both hardware packs. See Figures 4 - 6.
NOTE: Figures 4 and 5 are for the Free Standing configuration.
Figures 5 and 6 are for the Tandem/Modular configuration.
83
Column
66
Figure 1 Figure 2
C. Carefully place shipping
packages near area of
installation.
D. For Free Standing configurations,
allow a minimum amount 92” x
89” for operating space. See
Figure 1.
E. For Modular/Tandem
configurations, allow a minimum
of 92” x 76” for operating space.
See Figure 2. 92”
89”
92”
76”
Cybex Modular Owner’s Manual
Page 4-10