Cybex 55620H Modular - Manual (Page 93)

D. Verify that you received 20 weight plates.
E. Remove the two SHCS securing the guide rods.
F. Carefully lean guide rods away from column.
G. Remove guide rod collets and plastic caps.
H. Wipe guide rods clean over entire length. Lubricate with light coating of medium weight
automotive engine oil.
I. Install each weight plate one at a time. NOTE: Do not install the second weight and top
weight at this time.
J. Locate the spring pin 10 mm x 90 mm black (#39).
K. Slide the top weight plate onto second plate and carefully pound
the spring pin into the second weight plate hole, securing second
plate to the top plate. See Figure 15. NOTE: Insert pin so that it is
flush with the weight plate.
L. Install top weight.
M. Replace plastic caps and guide rod collets on guide rods.
N. Return guide rods to full upright position.
O. Insert both SHCS that were removed in step 6E (securing guide rods).
NOTE: Do not secure top weight at this time.
Figure 15
39
Pin
second
weight
Cybex Modular Owner’s Manual
Page 4-39