Cybex 55620H Modular User Manual

Page 94

Figure 16

7. Routing Cable (see steps 7A - 7J and Figure 16).

A. Install upper assemblies to any stations within the

Modular/Tandem configuration that contain upper
assemblies. See the Modular and Tandem
installation instructions.

B. Locate weight stack cable (#53), four pulleys (#1),

pulley mount (#40), three SHCS .375-16 x 1.75
(#29), one SHCS .375-16 x 2.00 (#26) and four
nylon locknuts .375-16 (#57) and one spiral pin
(#38).

C. Route cable to inside of column (#78). See Figure

16, letter D.

D. At the same time, install pulley to lower pulley

bracket and route cable (#53) using one pulley
(#1), one SHCS .375-16 x 1.75 (#29) and one
nylon locknut .375-16 (#57). See Figure 16,
letter D. Set cable down.

E. Attach one end of the weight stack cable (#53) to

the frame as shown in Figure 16 (using one SHCS
.375-16 x 1.75 (#29) and one nylon locknut .375-
16 (#57). See Figure 16, letter E.

F. NOTE: Do not install hanging pulley in this step.

At the same time, route cable (#53) and install the
last pulley before the weight stack (using one
SHCS .375-16 x 1.75 (#29) and one nylon locknut
.375-16 (#57). See Figure 16, letter F.

G. Pick up the other cable and install the pulley

mount (#40). Drive a spiral pin (#63H) through
cable end and pulley mount as shown in Figure
16, letter G.

H. Wrap a portion of the weight stack cable (#53)

around the last pulley (#1) to be installed. At
the same time, route cable (#53) and install
pulley (#1) using one SHCS .375-16 x 2.00
(#26) and one nylon locknut (#57).

I. Route cable downward to top plate. Slide rubber

boot (#63B) onto cable. Drive a spiral pin through
top plate connector and cable end. The top
weight should be snug (just resting on the next
plate). See Figure 16, letter H.

J. Slide rubber boot over top weight connector.

I, J

E, F

63B

63H

NOTE:

See the Modular
Assembly & Service
Manual for proper roll
pin adjustment (if
necessary).

Cybex Modular Owner’s Manual

Page 4-40