Cybex 55620H Modular - Manual (Page 177)

CABLE CROSSOVER
5311, 5648, 5649 AND 5650
ASSEMBLY & PARTS
NOTE: For tandem and quad (modular) configurations, follow
assembly guidelines listed on either the 5600 Modular Center Post
Assembly & Parts instruction sheet or the 5629 Tandem Center
Post Assembly & Parts instruction sheet. Also refer to all steps
listed below.
2. Read and understand instructions thoroughly before
assembling the Cable Crossover. Refer to the exploded-view
diagram and parts list when assembling the Cable Crossover.
3. Remove column from carton. For units with a back cover
(5311 and 5649), remove the cover before removing column
from carton. To remove cover, remove bolt securing cover at
the top end, then slide cover toward top end and lift out.
4. Install column to base (item #47). NOTE: 5648 and 5650
configurations do not have a base.
NOTE: For installing tandem and quad configurations, use
hardware items #58, #71 and #84.
5. For tandem configurations only (5648 and 5650),
install detent tube lower mount (item #78).
6. Install double pulley bracket (item #31).
7. Install weight stack.
8. Install crossbar mount (item #30) for 5311, 5649
and 5650. NOTE: Do not tighten screws at this
time. Crossbar must be loose when installing
crossover tube.
NOTE: For 5648 configuration, install detent tube
upper mount (item #79) in place of the crossbar
mount. Install plastic cap (item #80) into item #79.
9. Install right handle (item #34) and left handle (item
#33).
10. Install adjusting handle (item #37) to detent tube.
11. Install (chrome) detent tube (item #49).
12. Install adjusting bracket (item #45). NOTE: Do not
overtighten. Be sure pulley bracket swivels freely.
13. Install adjusting shield (item #50) and upper
pulley(#7) to handle assembly on the detent
(chrome) tube. See letter A in the Cable Routing
Detail diagram.
14. Route cable as shown in the Cable Routing Detail
diagram, starting with pulley B and continuing in
alphabetical order.
15. Adjust cable for one inch of free play.
16. Install crossover tube.
17. Tighten all hardware.
18. Install rear cover where applicable.
NOTE: This machine shipped with an Owner’s
Manual. Additional copies can be obtained by
contacting your dealer or a Cybex
Representative at 1-888-462-9239.
Assembly Notes (5311, 5648, 5649 and 5650)
1. Install unit in area where it will be used. Keep all shipping packages
near area of installation. Standard items include:
Shipping Package Model Configuration - 5311 5648 5649 5650
Cable Crossover Half Assembly - 5649 2 x 1 x
Tandem w/o Crossbar Assembly - 5648 x 1 x x
Tandem with Crossbar Assembly - 5650 x x x 1
Crossover Tube Package - 5649-003 1 x x x
Base Package - 5649-50 2 x 1 x
Top Weight Package - 4700-012 (black) 2 1 1 1
Weight Pack 1 - 4700S042 (black) 2 1 1 1