Cybex 55620H Modular - Manual (Page 55)

4 - Assembly
Page 4-1
Cybex Modular Owner’s Manual
TOOLS REQUIRED
• 5/16” Allen wrench
• Soft hammer
• Medium weight automotive engine oil
NOTE: Refer to the appropriate Assembly & Parts Instruction sheet (weight stack diagrams)
when performing the procedure listed below.
1. Remove the two socket head cap screws securing the guide rods.
2. Carefully lean guide rods away from column.
3. Remove guide rod collets and plastic caps.
4. Wipe guide rods clean over entire length. Lubricate with light coating of medium weight
automotive engine oil.
5. Install each weight plate one at a time, starting with the last plate (going from highest
numerical value to lowest). NOTE: For 15 and 25 weight plate stacks, the first plate installed
has no number. NOTE: When installing weight plates, position plates so wide edges of bushings
face upward and narrow edges of bushings face downward. See example below..
6. Install top weight.
7. Replace plastic caps and guide rod collets on guide rods.
8. Return guide rods to full upright position.
Weight Stack Installation
NOTE: Refer to Chapter 6 (Assembly and Service) for further assembly information.
CORRECT
NARROW bushing
edge
WIDE bushing
edge faces upward NOTE: The narrow
bushing edge must
face downward.
WRONG