Comtech EF Data MBT-5003 - Manual (Page 76)

MBT-5003 L-Band Up/Down Converter System Revision 1
Ethernet Management MN-MBT5003
6–20
6.5.5.4.2 Status | Status
Figure 6-10. Status | Status page
The ‘Status | Status’ page (Figure 6-10) is a read-only page that provides the user with all
pertinent information about the MBT-5003 operating configuration:
• General Information, including product identification (i.e., model and serial numbers),
active software image information, active operating temperature, and power readings for
the Base Unit, Converter A, and Converter B.
Note the following:
o Low Noise Amplifier (LNA) operation is not supported by the MBT-5003. All
parameter readings associated with this feature are therefore invalid.
o Valid Conv A/ConvB Forward RF Power readings are provided only if the
MBT-5003-XUR Up Converter is optionally configured with the Power Monitor
feature. These parameters otherwise will display as N/A if the pertinent converter
is an MBT-5003-XDR Down Converter.
• Firmware Information for Bootrom, Bulk Image#1 and Bulk Image #2.
• Part Numbers for the Base Unit, Converter A, and Converter B.