Comtech EF Data MBT-5003 - Manual (Page 49)

MBT-5003 L-Band Up/Down Converter System Revision 1
Front Panel Operation MN-MBT5003
5–9
If Trap is selected:
Trap Community: (◄ ►▲▼ E)
comtech
The user may view or edit the SNMP Trap Community string. To edit, first use the ◄
►arrows keys to select the character to edit, then the ▲ ▼ arrows keys to edit that
character. Press ENT when done.
If SNMP: Traps is selected:
SNMP Trap IP Address:
IP1 IP2 Version
Select IP1, IP2, or Version using the ◄ ► arrow keys to, then press ENT.
If SNMP Trap IP Address: IP1 or IP2 is selected:
Trap IP #1:
000.000.000.000 (◄ ►▲▼ E)
Trap IP #2:
000.000.000.000 (◄ ►▲▼ E)
The user may edit the Trap Destination’s IP Addresses. To edit, first use the ◄ ►
arrow keys to select the digit to edit, then the ▲ ▼ arrow keys to edit the value of that
digit. Press ENT when done.
Note: If both Trap IP Addresses are 000.000.000.000, it means Traps are disabled.
If SNMP Trap IP Address: Version is selected:
Trap Version:
SNMPv1 SNMPv2 (◄ ► E)
Select the trap version – SNMPv1 or SNMPv2 – using the ▲ ▼ arrow keys, then
press ENT.
5.3.1.2 CONFIG: FltRec (Fault Recovery)
Fault Recovery: Manual
Automatic
Select Manual or Automatic using the ◄ ► arrow keys, then press ENT.
5.3.1.3 CONFIG: ConvA or ConvB (Converter Unit ‘A’ or Converter Unit ‘B’)
Converter X
Mute/Freq Attenuation
Where ‘X’ is the selected converter – i.e., Converter (Unit) A or Converter (Unit) B – select
Mute/Freq or Attenuation using the ◄ ► arrow keys, then press ENT.