Comtech EF Data SNM-1001 - Manual (Page 90)

SNM-1001 Network Control Modem Remote Control Operation
Rev. 1 A–31
A.4.2 Error Performance
Raw BER Command:
Response: >add/RBER_xm.mE-ee'cr''lf'] Where:
x = < or > (data modifier to indicate that the error rate is
less than or greater than the returned value).
m.m = 1.0 to 9.9 (error rate mantissa).
ee = 1 to 99 (error rate exponent).
Notes:
1. The 'x' (< or >) parameter is only returned if the error
rate has exceeded the computational resolution of the
system.
2. "No Data" is returned if the error rate cannot be
calculated.
3. "Sampling" is returned if not enough data is currently
available to calculate the error rate.
Corrected
BER Command:
Response: >add/CBER_xm.mE-ee'cr''lf'] Where:
x = < or > (data modifier to indicate that the error rate is
less than or greater than the returned value).
m.m = 1.0 to 9.9 (error rate mantissa).
ee = 1 to 99 (error rate exponent).
Notes:
1. The 'x' (< or >) parameter is only returned if the error
rate has exceeded the computational resolution of the
system.
2. "No Data" is returned if the error rate cannot be
calculated.
3. "Sampling" is returned if not enough data is currently
available to calculate the error rate.