Comtech EF Data SNM-1001 - Manual (Page 74)

SNM-1001 Network Control Modem Remote Control Operation
Rev. 1 A–15
A.4 Status Commands/Responses
A.4.1 Configuration
Modulator
Config
Status Command:
Response: >add/MCS_'cr'
RF_xxx'cr'
MF_nnn.nnnn'cr'
MR_nnnn_mmm.mmm'cr'
AMRA_nnnn_mmm.mmm'cr'
AMRB_nnnn_mmm.mmm'cr'
AMRC_nnnn_mmm.mmm'cr'
AMRD_nnnn_mmm.mmm'cr'
AMRV_nnnn.mmm.mmm'cr'
MPO_snn.n'cr'
MOP_snn.n'cr'
SE_xxx'cr'
DENC_xxx'cr'
MT_xxxx'cr'
MET_xxx'cr'
TDA_xxx'cr'
COM_xxx'cr'
RSEN_xxx'cr'
MSR_xxx'cr''lf']
RF Output (ON/OFF)
Modulator Frequency
Modulator Rate
Preset 'A' Assignment
Preset 'B' Assignment
Preset 'C' Assignment
Preset 'D' Assignment
Preset 'V' Assignment
Modulator Power Offset
Modulator Output Power
Scrambler Enable (ON/OFF)
Differential Encoder (ON/OFF)
Modulator Type
Modulator Encoder Type
Transmit BPSK Data Ordering
Carrier Only Mode (ON/OFF)
Reed-Solomon Encoder (ON/OFF)
Modulator Spectrum Rotation
The modulator configuration status command causes a block
of data to be returned by the addressed modem. The block of
data reflects the current configuration status of the modulator
module.