Comtech EF Data SNM-1001 - Manual (Page 82)

SNM-1001 Network Control Modem Remote Control Operation
Rev. 1 A–23
Bulk Consol
Analog
Status Command:
Response: >add/BCAS_p1,p2,p3, . . . pn'cr''lf'] This command is similar to the 'BCS_' command but, returns
modem analog parameters.
Where 'pn' is the last parameter returned.
Parameter
Number
Parameter Name
(Command Reference)
Description
1
2
3
4
5
Receive Signal Level
(ref. "RSL_" command).
Raw BER
(ref. "RBER_" command).
Corrected BER
(ref. "CBER_" command).
E b /N 0
(ref. "EBN0_" command).
Current Sweep Value
(ref. "CSV_" command).
p1 = xsnn.n, receive signal level in dBm.
p2 = xm.m -ee .
p3 = xm.m -ee .
p4 = xnn.n, E b /N 0 in dB.
p5 = snnnnn, sweep offset value in Hz.
Note: Parameters 2 through 5 are dependent on carrier acquisition, if the decoder is not locked empty data blocks are returned
(,,,,).