Comtech EF Data SNM-1001 - Manual (Page 81)

Remote Control Operation SNM-1001 Network Control Modem
A–22 Rev. 1
Current
Sweep
Value Command:
Response: >add/CSV_snnnnn'cr''lf'] Where:
x = < or > (data modifier to indicate that the sweep offset
value is less than or greater than the returned value).
s = + or - (sweep offset from center).
nnnnn = 0 to 35000.
Notes:
1. This command returns the current sweep offset value.
2. The 'x' (< or >) parameter is only returned if the level
has exceeded the computational resolution of the
system.
3. "No Data" is returned if the level cannot be calculated.
4. "Sampling" is returned if not enough data is currently
available to calculate the level.
Interface
Analog
Loopback
Jumper
Status Status:
Response: >add/ALBJ_xxx'cr''lf'] Where: xxx = ON or OFF.
Note: Only valid when ADPCM board is installed.